Hi All... First Post with probably a very basic question.... but see Introduction and be gentle!!! ( I did as first point, contact Kentec tech help - and thought I understood what I was told, but wasn't on site at time.... so means nothing now! and I don't want to ask again and they will think I am stupid!.... AND| I can do stupid all on my own without Tech Support thinking that too cheers!!!)
So, Background:
I have just been Commissioning a Warehouse type Storage Unit where the Designer specified a Remote PSU to allow larger Batteries for a Kentec Syncro AS 2 Loop, 16 Zone Pane using Apollo XP95 devices. Probably due to the premises being 24hr access and unmanned at various periods. It is/will be Linked to Monitoring via the Security System for fault and Fire?.
I have never over the years dealt with Remote PSU before (only separate Battery enclosures)
The Remote PSU is a KD25250 with the Dual Output Path Monitor module Fitted.
I had to get the Installers to run a 2nd Cable for the Dual Output (once I read the 'manual' that came with it!) and that's all fine.
The Syncro PSU - although in place has been disconnected by Main's Fuse removal and unplugging the 24v supply from circuit board currently (as wasn't sure if could run BOTH supplies??)
So My QUESTION:
What exactly do I NEED TO DO - so that the remote PSU reports power failures direct to the Panel (rather than just on the R/PSU Display? ) which is located away from the Panel??
There is a PF terminal on the Syncro panel which I guess is for PowerFail .... but I not sure how I link that from the remote PSU to Panel?
BASIC DETAILED advice would be much appreciated ..... ie.... Connect Brown to Terminal X in Panel or PSU?? and to Terminal X in Panel or PSU?? AND Connect Blue(s) to Terminal Y...... etc etc .......and anything in between, Links resistors etc :) :)
Many thanks Hoping this makes sense to someone and looking forward to some help.
Cheers
yangi
So, Background:
I have just been Commissioning a Warehouse type Storage Unit where the Designer specified a Remote PSU to allow larger Batteries for a Kentec Syncro AS 2 Loop, 16 Zone Pane using Apollo XP95 devices. Probably due to the premises being 24hr access and unmanned at various periods. It is/will be Linked to Monitoring via the Security System for fault and Fire?.
I have never over the years dealt with Remote PSU before (only separate Battery enclosures)
The Remote PSU is a KD25250 with the Dual Output Path Monitor module Fitted.
I had to get the Installers to run a 2nd Cable for the Dual Output (once I read the 'manual' that came with it!) and that's all fine.
The Syncro PSU - although in place has been disconnected by Main's Fuse removal and unplugging the 24v supply from circuit board currently (as wasn't sure if could run BOTH supplies??)
So My QUESTION:
What exactly do I NEED TO DO - so that the remote PSU reports power failures direct to the Panel (rather than just on the R/PSU Display? ) which is located away from the Panel??
There is a PF terminal on the Syncro panel which I guess is for PowerFail .... but I not sure how I link that from the remote PSU to Panel?
BASIC DETAILED advice would be much appreciated ..... ie.... Connect Brown to Terminal X in Panel or PSU?? and to Terminal X in Panel or PSU?? AND Connect Blue(s) to Terminal Y...... etc etc .......and anything in between, Links resistors etc :) :)
Many thanks Hoping this makes sense to someone and looking forward to some help.
Cheers
yangi