I have just started to service an ID2000 panel but keep getting suspected break loop 1.
I looked in the panel and loop 1 is linked out at the actual connections as well as powering the loop.
I am guessing it believes that there is a break becuase because a device has gone short or missing on the loop.
But when I look through the history of events I don't get any missing devices so don't know where to start looking for a problem.
Any help would be appeciated.
Can you get a config tool for this panel or do you need to be a Notifer approved agent?
I have had to create a list of devices usiung Putty an rs232 recording tool and displaying all sensors and modules.
Any help is appreciated.
I looked in the panel and loop 1 is linked out at the actual connections as well as powering the loop.
I am guessing it believes that there is a break becuase because a device has gone short or missing on the loop.
But when I look through the history of events I don't get any missing devices so don't know where to start looking for a problem.
Any help would be appeciated.
Can you get a config tool for this panel or do you need to be a Notifer approved agent?
I have had to create a list of devices usiung Putty an rs232 recording tool and displaying all sensors and modules.
Any help is appreciated.